Drain Plumbers – Drain Line Installation

Most drain line installations are normally fairly simple procedures so long as the appropriate planning is taken into account beforehand. Sometimes it could be necessary to call in an expert drain plumber, however, with the appropriate tools and a bit of know-how, this project is readily accomplished by the home-owner itself.

Drain Plumbers - Drain Line Installation

Step 1: Plan the Piping

Many various kinds of fittings and piping exist, each made with the aim of functionality. When planning your system, bear in mind the various sizes you'll need and whether the sizing will change on the way. Knowing the angles to account for in addition to the diameter of the piping will finally determine what materials to buy.

Step 2: Cut the Pipe

Together with your goggles on, use the hacksaw to cut the lengths of pipe. Make sure you note which part goes where to be sure the method runs smooth as possible. When the tubes are cut, use a sheet of sandpaper to smooth the edges, and employ cleaning solvent to wash the ends.

Step 3: Check Your Measurements

Before gluing the ends, match the piping together to ensure that your measurements are correct. You'd hate to have the halfway. This way, you'll have the ability to tell whether the machine will work before making it permanent.

Step 4: Install Drain Line

Mark the walls and ceiling at the regions where the pipe is going to be conducted and where the pipe girders will be set up. The girders act to stabilize the pipes as they run across the walls. Place these inches. 


Post navigation